Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
See the difference
Before
After
Before
After
Before
AfterHow Much Does Gate Motor & Opener Cost in Pomona?
In Pomona, a gate motor and opener upgrade typically runs $1,450 to $4,800 installed, depending on the operator brand and whether the gate is a single swing, double swing, or sliding system. Replacing just the motor and control board on an existing gate you already like usually lands at the lower end, around $1,450 to $2,600. A full new automated system on a double swing driveway gate with access control runs $3,800 to $4,800, sometimes more on heavy ornamental steel.
Those numbers are for 2026 and reflect what we quote across Pomona’s neighborhoods, from Lincoln Park bungalows with a single pedestrian gate to the wider driveway gates around Phillips Ranch. Call (855) 382-5690 for a free, exact estimate.
Gate Motor & Opener Cost Breakdown (2026)
Prices below are what we see on actual Pomona jobs in 2026. Your final quote depends on the gate, the operator you choose, and how much site work is needed. We service LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule, so we can price a replacement against the system you already own rather than steering you toward a brand we stock.
| Line item | Typical range (Pomona, 2026) |
|---|---|
| Motor + control board replacement (existing gate) | $1,450 – $2,600 |
| New single swing operator, installed | $1,600 – $2,900 |
| New double swing operator (dual arms), installed | $2,900 – $4,800 |
| New sliding gate operator, installed | $2,600 – $5,200 |
| Access control integration (keypad, remote receiver, phone entry) | $250 – $900 |
| Safety sensor / photo-eye installation | $150 – $450 |
| Battery backup add-on | $180 – $400 |
| Wi-Fi / smart-control module | $120 – $350 |
| Labor for wiring, conduit, and site prep | $300 – $1,100 |
| Emergency diagnosis | $125 – $275 |
What pushes a bill to the top of a range: a heavy steel or ornate wood gate that needs a bigger-duty operator, a long wire run back to the house, or an older home where the electrical panel is far from the gate. What pulls it down: you keep your existing gate, the mount is already in place, and no new conduit is needed. In Pomona we see a lot of mid-century homes where the gate was added decades after the house was built, and the wiring was never properly run to the property line. That site work is the wild card in most quotes.
What Affects Gate Motor & Opener Pricing in Pomona
- Gate type and weight. A sliding gate on a track needs a different operator than a swing gate, and heavy ornamental iron needs a higher-torque motor than a lighter aluminum or wood gate. Matching the operator to the actual gate load is where the quote starts moving.
- Existing hardware and brand. If you already have a LiftMaster or FAAC operator, the fix can often reuse part of the mount and wiring, which saves money. If we’re switching brands, the mounting and wiring usually need rework. We diagnose what you have first, so we don’t sell a full replacement when a specific part is the real culprit.
- Electrical access at the gate. Pomona has plenty of homes where the panel is on the far side of the house from the driveway gate. Running conduit across a yard or under a driveway adds real cost. If there’s already power at the gate, you skip that line item entirely.
- Access control needs. A plain clicker is cheap. Adding a keypad, a phone-entry system, or integrating with a property manager’s access software raises the number, because it means pulling wire, cutting in a reader, and configuring the controller.
- Safety sensors and code compliance. Any operator we install today includes safety photo-eyes so the gate reverses if something is in the way. That’s not optional and it adds to the bill, but it’s what keeps a gate from closing on a child or a car.
- Permits and HOA rules. Pomona driveway and electric gate work can require a permit, and some HOAs have rules on gate height, style, and visibility. We factor permit and HOA review into the quote up front so there are no surprises mid-install.
One local pattern we see: the older ranch and bungalow neighborhoods get hit by summer heat that cooks the control board and battery, while winter rain finds its way into the operator housing and corrodes connections. If your gate acts up every July or every February, that’s usually a housing, drainage, or ventilation issue we can address during the install, rather than a sign your gate needs to be replaced.
How to Save on Gate Motor & Opener
You don’t always need a full new system. A lot of the calls we take turn into a repair rather than a replacement once we put eyes on the hardware, and that’s the honest answer we’ll give you even when it means a smaller bill.
- Diagnose before you replace. Brand-specific fault codes matter. A Mighty Mule that won’t open isn’t the same failure as a DoorKing that won’t open. Getting the diagnosis right the first time saves you a second or third service call.
- Keep your existing gate. If the gate itself is solid, swapping the operator on it is the least expensive path. You pay for the hardware and the install, not for a whole new gate.
- Bundle the access control at install. Adding a keypad or Wi-Fi module while the technician is already on site costs less than a return trip to add it later.
- Fix the housing and drainage while you’re in there. A little prevention on the enclosure goes a long way toward keeping a Pomona heat-and-rain problem from coming back.
- Get a free written estimate. Call (855) 382-5690 and we’ll quote it at no cost, with the parts and labor broken out so you can see exactly where the money goes.
If you want to see the full range of what we handle on this kind of work, our Gate Motor & Opener in Pomona service covers the repair and installation options in more detail.
One note of caution worth stating plainly: gate operators run on line voltage, and the springs, tracks, and moving arms on a powered gate carry real force. If a gate has lost power or is behaving erratically, please don’t reach into the operator or try to force the arm by hand to see what’s wrong. That’s the kind of work that belongs with a trained technician who knows the brand and can do it safely. We’d rather come out and diagnose it than have you get hurt.
FAQs – Gate Motor & Opener Cost
How much does it cost to install a gate motor in Pomona? A new single swing operator installed in Pomona typically costs $1,600 to $2,900 in 2026, while a double swing runs $2,900 to $4,800 and a sliding operator $2,600 to $5,200. Call (855) 382-5690 for an exact quote, and estimates are free.
Is it cheaper to repair or replace my gate opener? Repair is usually cheaper when the gate and wiring are in good shape. A motor and control board replacement on an existing gate runs $1,450 to $2,600, which is often well under a full new system. The right call depends on whether the brand you have is still serviceable, and we service all nine major brands, so we can tell you honestly. Call us to find out.
How much does emergency gate repair cost in Pomona? A diagnosis in Pomona runs $125 to $275, and the repair itself is quoted separately on top of that. We’ll get you the exact number when you call (855) 382-5690, free.
Can I add a keypad or phone entry to my existing gate? Yes, and it typically adds $250 to $900 depending on the system. Adding it during an install costs less than a separate visit. Call (855) 382-5690 and we’ll price it with your gate in mind.
Do I need a permit for an electric gate in Pomona? Often yes, and some HOAs also review gate height and style. We build permit and HOA considerations into the quote so nothing blindsides you later. Call for a free estimate and we’ll walk you through what applies to your property.
If your gate is stuck, noisy, or you’re ready to automate a manual one, the fastest path is a call. We’re an electric gate specialist working on gates only, across nine brands, with the same team handling repair and installation so you don’t need a second contractor when a fix turns into a replacement. For a free estimate in Pomona, call (855) 382-5690. We aim to have you back in service today.
Pricing reflects the Pomona market as of 2026. Gate Repair Pomona offers free estimates – call (855) 382-5690. Written by the team at Gate Repair Pomona, serving Pomona and the surrounding area.
What Our Customers Say
"Control board fried after a lightning storm. He showed me the burn mark on it, quoted the board, and installed a surge protector on the line so it hopefully doesn't happen again."
- Steven Nguyen"Reprogrammed every clicker in the HOA and set up the keypad codes. Patient with a very long list of residents."
- Alma Reyes"Solar panel on our remote gate wasn't keeping the battery up through the winter. He repositioned it, replaced the battery, and explained the math on why the old placement was never going to work."
- Laura Delaney