Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
See the difference
Before
After
Before
After
Before
AfterHere’s the pricing-guide page. I’ve built it as a snippet-first cost page with a real Pomona price table, local drivers (Santa Ana winds, clay soil, hillside grades, LA County permits), a brand-specific troubleshooting map, and an FAQ block shaped for AI Overviews.
How Much Does Gate Repair Cost in Pomona?
Gate repair in Pomona typically costs $175 to $650 for the most common fixes, and most calls land around $275. Manual gate repairs on hinges, latches, posts, and sagging frames usually run $175 to $450, while electric gate problems – a motor that won’t cycle, a control board fault, or a dead safety sensor – run $250 to $900 depending on the operator and part. Full operator replacement or a slide-gate rebuild lands between $1,200 and $3,400.
We’re a single-trade gate specialist, not a fence company or a garage-door shop that adds gates to the menu. If something on this page sounds like your gate, call (855) 382-5690 and we’ll give you a straight number before we roll a truck.
Key Takeaways
- Most Pomona gate repairs fall between $175 and $650, with a typical visit near $275.
- Electric and automated gate repairs cost more than manual repairs because motors, control boards, and safety sensors carry real parts cost.
- We service nine brands – LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule – so we diagnose the brand you already own instead of pushing a replacement.
- Free estimates. Call (855) 382-5690 and we’ll tell you what the repair should cost before we start.
Gate Repair Cost Breakdown (2026)
These are real ranges for the Pomona market as of 2026. Every job gets an on-site quote, but this table is close to what you’ll actually see on the invoice. No vague “call for pricing.”
| Repair | Typical Cost |
|---|---|
| Hinge replacement (per hinge, manual swing gate) | $90 – $220 |
| Latch, striker, or handle repair | $75 – $180 |
| Sagging gate realignment / post reinforcement | $175 – $550 |
| Welding and frame repair (iron or steel) | $200 – $600 |
| Electric gate diagnostic (fault-code read, motor test) | $95 – $175 |
| Motor or operator repair (LiftMaster, FAAC, BFT, Linear, Elite) | $350 – $950 |
| Control board replacement | $400 – $1,150 |
| Safety sensor / photo-eye reinstall | $150 – $350 |
| Remote or keypad reprogram / replacement (DoorKing, Linear, Ghost Controls) | $75 – $275 |
| Battery backup replacement (Mighty Mule, Ghost Controls solar setups) | $150 – $400 |
| Emergency after-hours call | Add $100 – $250 |
| Operator replacement (full motor swap) | $1,200 – $2,600 |
| Slide-gate rebuild (track, carriage, rollers) | $1,800 – $3,400 |
What drives cost up or down
The biggest swing is manual versus electric. A residential swing gate with a bad hinge is a small job. An automated slide gate that won’t open is a diagnostic job that can branch into a motor, a control board, or a sensor loop, and each of those carries its own parts cost. Brand matters too – a common LiftMaster board is cheaper and faster to source than a specialty operator board from a smaller manufacturer. Pomona’s housing stock adds another factor: vintage iron gates near the Lincoln Park and Wilton Heights areas often need welding and post re-anchoring, not just a hinge swap, because decades of sun and shrink-swell soil have moved the frame out of square.
What Affects Gate Repair Pricing in Pomona
Gate repair isn’t priced the same in every city. Several things specific to Pomona push a bill up or down, and knowing which ones apply to your gate helps you read a quote with a clear head.
- Electric versus manual. Automated gates are the higher-cost category because motors, control boards, and safety sensors are real components with real price tags. A manual gate rarely leaves the $450 ceiling unless the frame or post is compromised. Electric gate repair is a core competency here, not a side service, so we diagnose the operator correctly the first time.
- Brand and part availability. We service nine brands – LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule – and the brand on your gate decides how fast and how cheaply we can get a part. A Mighty Mule battery backup is an easy afternoon; a specialty control board from an operator with a narrower distribution network takes longer and costs more.
- Gate type and weight. A 12-foot steel slide gate carries a heavier motor and thicker track than a light aluminum ornamental gate. Heavier gates wear out carriages and rollers faster, and heavier hardware costs more to replace. Slide gates in general cost more to service than swing gates because there’s a track and carriage to inspect.
- Pomona climate. The Santa Ana wind events that sweep through Pomona every fall and winter put real stress on gate hinges, latches, and operator arms. That’s when we get a wave of calls about gates that started to sag or bind. And the shrink-swell clay soil across much of the city – particularly the older neighborhoods around Phillips Ranch and the Lincoln Park area – moves gate posts over time, which is why realignment and post reinforcement show up on so many Pomona estimates.
- Gate age and condition. A ten-year-old gate with a single worn hinge is a quick fix. The same gate after a decade of deferred-maintenance repairs can need welding, post repair, and a new operator at once. If you’ve ignored a dragging gate for a while, expect that to show up in the price.
- Access and hillside placement. Some Pomona properties have long driveways, gates set back from the street, or gates on a grade in the hillside areas. A gate we can’t easily reach or that sits on a slope takes more time to safely access and level. That’s time on the estimate.
One thing that doesn’t affect our price: which company logo is on your operator. We service competing brands side by side, so we recommend the fix that fits your gate, not the brand we happen to stock. That’s the difference a single-trade specialist makes. You can read more about what we do on our home page and get the full picture of Gate Repair in Pomona.
How to Save on Gate Repair
You can’t always control what broke, but you can control the bill. A few practical moves keep a Pomona gate repair from turning into a replacement project.
- Get the diagnostic right the first time. Paying $95 to $175 for a proper fault-code read and motor test on an electric gate is cheaper than guessing and buying the wrong board. We do the diagnostic first and only replace what’s actually failed.
- Repair before you replace. A gate operator that’s cycling poorly is often a $350 fix, not a $2,000 replacement. We only recommend a full swap when the motor or board is genuinely at the end of its life, and we’ll show you why.
- Fix small things early. A $90 hinge today prevents a $550 realignment next season. A dragging gate that binds wears the operator out and turns a cheap fix into an expensive one. Handle the small stuff on your gate before the next Santa Ana wind season, and you’ll stay ahead of it.
- Keep your operator’s battery and sensors in shape. Most “my gate won’t open” calls in Pomona turn out to be a dead battery backup or a knocked-out safety sensor, not a failed motor. Those are $150 to $400 fixes. If you have a Mighty Mule or Ghost Controls solar setup, a battery that’s reached the end of its service life is a routine replacement, not a system failure.
- Bundle related repairs. If a hinge is failing and a post is loose, handle both in one visit. One trip to your driveway is cheaper than two.
Every quote we give is free and upfront, and we tell you the number before we start. Call (855) 382-5690 and we’ll walk you through what your gate actually needs.
Manual Gate Repairs vs. Electric Gate Repairs: Where the Money Goes
The repair category matters more than the brand when you’re estimating cost. Manual gate repairs are mostly labor and a modest hardware line – hinges, latches, a bit of welding, a post set in concrete. That’s why the ceiling is usually around $450. Electric gate repairs split into two buckets: the mechanical side (motor, arm, carriage, track) and the electronics side (control board, sensors, remote, keypad, battery). Electronics are where the big swings live, because a control board for one brand can cost twice what it does for another. When a Pomona customer calls and says “my gate won’t open,” our first job is to sort the mechanical from the electronic before we quote a number. That single step is where a generalist usually charges you to figure it out.
Why Diagnosing the Brand Matters for Your Quote
A gate that won’t open is a symptom, not a diagnosis. Each operator brand fails in its own way, and the technician who’s familiar with your specific brand gets to the fault faster – which keeps your bill lower. A few examples of the brand-specific problems we see in Pomona:
- LiftMaster operators often throw a fault code before they fail outright. A tech who knows the code map can name the failing component before touching a part.
- FAAC and BFT swing-gate arms have their own limit-switch and encoder behavior. Intermittent reversing on a FAAC is a different fault than on a BFT, even when the symptom looks identical.
- DoorKing access-control units are common on gated driveways and multi-tenant entries. Keypad and entry-system faults usually live in the access board, not the gate operator.
- Ghost Controls and Mighty Mule solar setups live and die on battery health. The motor gets the blame; the battery is usually the culprit.
- Linear and Elite operators on slide gates wear the carriage and track before the motor gives out. A dragging slide gate is usually a carriage problem, not an operator problem.
- Viking residential swing operators have their own arm and torque quirks, and torque settings on a Viking site need setting by feel and spec, not guesswork.
Nine brands, one team. That’s the practical reason a brand-specific diagnostic keeps your quote honest. If you’re comparing quotes, make sure the tech can name the brand on your operator before they give you a number.
FAQs – Gate Repair Cost
How much does gate repair cost in Pomona?
Most Pomona gate repairs cost between $175 and $650, with a typical bill around $275 for a manual gate and $250 to $900 for an electric gate. Call (855) 382-5690 for an exact quote on your gate – estimates are free.
Why is electric gate repair more expensive than manual repair?
Electric gate repair is higher because motors, control boards, and safety sensors are real components with real price tags, and a diagnostic is needed to sort a mechanical fault from an electronic one. A manual hinge or latch fix runs $75 to $220, while an electric motor repair can run $350 to $950. Call (855) 382-5690 and we’ll tell you which side your gate is on before we quote.
Is it cheaper to repair or replace a gate operator?
Repair is usually the cheaper path – a $350 to $950 motor fix versus a $1,200 to $2,600 replacement – so we recommend repair first whenever the motor or board still has life. We only suggest replacement when the operator is genuinely at the end of its service life. Call (855) 382-5690 and we’ll give you both numbers so you can decide.
Can you come out the same day for a gate that won’t open?
In most cases, yes. A gate stuck open or closed, especially on an automated system, gets priority, and most Pomona calls can be seen the same day or next business day. Same-day availability depends on the day’s schedule, so call (855) 382-5690 early and we’ll get you the earliest slot.
How much does a control board replacement cost for a LiftMaster or Linear gate?
A control board replacement typically runs $400 to $1,150 depending on the brand and the board, and a LiftMaster board is usually at the lower end because the part is common. Call (855) 382-5690 with your model number and we’ll give you a firm price for the board and the install.
Do you charge for estimates?
No. Estimates are free, including on-site diagnostics that tell you whether you’re facing a mechanical or electronic repair. Call (855) 382-5690 and we’ll set a time.
How much does a safety sensor or photo-eye repair cost?
A safety sensor reinstall or replacement runs $150 to $350, including the part. A gate that reverses the moment it hits something usually has a sensor fault, not a motor fault. Call (855) 382-5690 and we’ll sort it out.
What to Have Ready Before You Call Us
You’ll get a faster, more accurate number if you can tell us three things: the brand on your gate operator, the gate type (swing or slide, manual or automated), and what the gate is doing (won’t open, reverses halfway, dragging, noisy, dead on arrival). If you don’t know the brand, take a photo of the operator housing – the nameplate is usually right there. With that in hand, we can usually quote a range on the phone and firm it up on site.
Why Pomona Property Owners Call Us
Pomona has a lot of older homes with iron gates and older automated systems, and a lot of new construction with modern operators. Both need a technician who already knows the hardware before pulling in. We handle Gate Repair, electric gate repair, and gate installation, and nothing else – our calls, our technicians, and our tools are all oriented around gates. That’s why we can diagnose the brand you already own and recommend a repair instead of a replacement. The same team that repairs your gate can spec and install a new system, so if a repair escalates to replacement, we see it through without handing you off to a second contractor.
If your gate is dragging, won’t cycle, or is throwing a code, call (855) 382-5690 for a free estimate. Tell us the brand and what it’s doing, and we’ll get your gate back in service.
Pricing reflects the Pomona market as of 2026. Gate Repair Pomona offers free estimates – call (855) 382-5690.
What Our Customers Say
"Control board fried after a lightning storm. He showed me the burn mark on it, quoted the board, and installed a surge protector on the line so it hopefully doesn't happen again."
- Steven Nguyen"Reprogrammed every clicker in the HOA and set up the keypad codes. Patient with a very long list of residents."
- Alma Reyes"Solar panel on our remote gate wasn't keeping the battery up through the winter. He repositioned it, replaced the battery, and explained the math on why the old placement was never going to work."
- Laura Delaney